reseaux_administrations
Différences
Ci-dessous, les différences entre deux révisions de la page.
Les deux révisions précédentesRévision précédenteProchaine révision | Révision précédenteProchaine révisionLes deux révisions suivantes | ||
reseaux_administrations [2011/01/23 21:10] – thierry | reseaux_administrations [2011/11/09 21:35] – thierry | ||
---|---|---|---|
Ligne 5: | Ligne 5: | ||
====== Bonding ====== | ====== Bonding ====== | ||
- | Lien: http:// | + | Liens: |
+ | *http:// | ||
+ | *http:// | ||
+ | *http:// | ||
+ | *http:// | ||
+ | Switchs: | ||
+ | *http:// | ||
+ | *http:// | ||
+ | |||
+ | Bonding ⇔ LACP (802.3ad) chez Cisco | ||
+ | |||
+ | # aptitude install ifenslave | ||
+ | |||
+ | **''/ | ||
+ | ... | ||
+ | auto bond0 | ||
+ | iface bond0 inet static | ||
+ | address 10.0.4.10 | ||
+ | netmask 255.255.255.0 | ||
+ | gateway 10.0.4.254 | ||
+ | bond-slaves eth0 eth1 | ||
+ | bond-mode < | ||
+ | bond-miimon 100 | ||
+ | bond-primary eth0 eth1 | ||
+ | |||
+ | *bond-mode 0 => Round-robin policy (envoi alternativement d'une interface puis de l' | ||
+ | *bond-mode 1 => Active-backup policy (active 1 slave, et passe au suivant en cas de defaillance) | ||
+ | *bond-mode 4 => IEEE 802.3ad Dynamic link aggregation | ||
+ | |||
+ | |||
+ | Autre exemple: | ||
+ | auto bond0 | ||
+ | iface bond0 inet static | ||
+ | address 10.21.4.11 | ||
+ | netmask 255.255.255.0 | ||
+ | network 10.21.4.0 | ||
+ | broadcast 10.21.4.255 | ||
+ | gateway 10.21.4.254 | ||
+ | bond-slaves none | ||
+ | bond-mode 4 | ||
+ | bond-miimon 100 | ||
+ | |||
+ | allow-hotplug eth0 | ||
+ | iface eth0 inet manual | ||
+ | bond-master bond0 | ||
+ | bond-primary eth0 eth1 eth2 | ||
+ | |||
+ | allow-hotplug eth1 | ||
+ | iface eth1 inet manual | ||
+ | bond-master bond0 | ||
+ | bond-primary eth0 eth1 eth2 | ||
+ | |||
+ | allow-hotplug eth2 | ||
+ | iface eth2 inet manual | ||
+ | bond-master bond0 | ||
+ | bond-primary eth0 eth1 eth2 | ||
+ | |||
+ | Pour les switchs, voir chez Cisco... | ||
+ | |||
+ | Sur le switch: | ||
+ | #conf t | ||
+ | #interface range gi 1/0/3 - 4 | ||
+ | # | ||
+ | #switchport mode access | ||
+ | #switchport access vlan 6 | ||
+ | |||
+ | Marche | ||
+ | *channel-group 1 mode on => bond-mode 0 | ||
+ | *channel-group 1 mode passive | ||
+ | *channel-group 1 mode active | ||
+ | |||
+ | Un " | ||
+ | #sh ru interface po1 | ||
+ | Building configuration... | ||
+ | |||
+ | Current configuration : 31 bytes | ||
+ | ! | ||
+ | interface Port-channel1 | ||
+ | | ||
+ | | ||
+ | end | ||
+ | |||
+ | #sh etherchannel summary | ||
+ | ... | ||
+ | Number of channel-groups in use: 1 | ||
+ | Number of aggregators: | ||
+ | |||
+ | Group Port-channel | ||
+ | ------+-------------+-----------+----------------------------------------------- | ||
+ | 1 Po1(SU) | ||
====== Arp ====== | ====== Arp ====== | ||
Ligne 71: | Ligne 161: | ||
====== nfs ====== | ====== nfs ====== | ||
- | Lien: http:// | + | Liens: |
+ | * http:// | ||
+ | * IPTABLES et NFS: http:// | ||
===== serveur ===== | ===== serveur ===== |
reseaux_administrations.txt · Dernière modification : 2011/11/25 11:21 de thierry